step 1 >> copier control system will not enable copier.
Check to see that that the ADD-4 System is connected to the copier.
problem not resolved, next step >>
<< back to troubleshooting list
<< back to Trouble-shooting home page
step 2 >> copier control system will not enable copier.
Check for bent pins on each side of the keyswitch.
Remove the copier cable
from the keyswitch.
Look into the keyswitch. Check to see that no pins are bent.
If any pins are bent, straighten them out so they mate with the cable connector.
Reconnect the cable to the keyswitch
Repeat this procedure for the opposite side of the keyswitch, removing the keyswitch module cable.
problem not resolved, next step >>
<< back to troubleshooting list
<< back to Trouble-shooting home page
step 3 >>>copier control system will not enable copier.
Remove the copier interface cable from the keyswitch.
Look closely at the connections within the 12-position connector. If any of the wires within the connector have come loose or are detached, contact Transaction Recovery Systems.
A - shows faulty connection
<< back to troubleshooting list
<< back to Trouble-shooting home page